Advertisement
DO nOt carry the glue gun with your finger on the power switch, or carry by the power cable.
8
DO nOt use the glue gun where there are flammable liquids, solids or gases such as paint solvents, etc.
8
DO nOt leave the glue gun operating unattended.
8
When not in use switch the glue gun off, remove plug from the power supply, store the tool in a safe, dry child proof area.
9
nOtE: this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or
9
lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of
the appliance by a person responsible for their safety. children should be supervised to ensure that they do not play with the appliance.
2. intrODuctiOn
composite housing with comfortable handle and trigger feed control. Fitted with 1.1mtr cable with BS approved 3-pin 230V rewireable fused plug.
suitable for hardwoods, softwoods, plastics and other similar materials. includes two glue sticks.
3. SpEciFicAtiOn
model no: ............................................................... AK292.V3
Power: .............................................................................40W
supply: ...........................................................................230V
consumables: ......AK292/2 All purpose glue stick pack of 25
4. OpErAtiOn
WArning! Remember that whilst operating the gun, both the dispensing nozzle and the glue itself are hot. DO nOt allow the nozzle
‰
or glue to come into contact with any part of your body or that of anybody else who may be assisting you.
4.1
prEpArAtiOn
4.1.1
ensure the work surface is clean and clear before engaging in the task in hand.
4.1.2
steady the workpiece with an appropriate vice or clamp.
4.1.3
Insert the glue stick firmly into the inlet and plug the glue gun into the mains.
4.2
uSE
4.2.1
Squeeze the trigger several times to insert the stick into the gun.
4.2.2
Leave the gun to warm up for approximately 5 minutes.
4.2.3
Squeeze the trigger firmly until glue flows from the nozzle.
4.2.4
When the task is complete, unplug the gun and leave to cool.
4.2.5
No cleaning is required. DO nOt attempt to remove the glue stick from the gun as this may cause damage to the product and/or
personal injury.
WEEE rEgulAtiOnS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
Warranty: guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey group, Kempson Way, Suffolk Business park, Bury St Edmunds, Suffolk. ip32 7Ar
01284 757500
© Jack sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
AK292.V3| Issue: 2(L) 07/07/17
Advertisement
