Rinnai Linear 1500 Installation Manual

Linear 1500
Burn media installation
Experience has shown that the majority of performance problems are caused by burn media being
installed incorrectly. Please take the time to read and follow these instructions as malfunctioning
due to incorrect burn media placement is not covered by warranty.
• The Linear MUST NEVER be used with other burn media or burn media that is damaged.
• The Linear burn media sets are different and cannot be interchanged, ensure you have ordered
the correct set before installation.
Correct placement
It is important to place the burn media in the correct position. Incorrect placement can create
carbon build-up and affect performance.
Single-sided/double-sided
When installing the burn media you will ALWAYS be working on the side where the pilot assembly
is to the back of the firebox.
R2903 Linear 1500 driftwood log set kit contents
Part number Description
13044 Vermiculite
13476 Wire wool (glowing ash)
13480 Log set A and stone set
13481 Log set B
Log set A and stone set come packaged in the same box
1
R2905 Linear 1500 modern media kit contents
Part number Description
13473 Crushed black glass
13476 Wire wool (glowing ash)
Important
Ensure the gaps between the burners are kept clear of any vermiculite or crushed glass. This is
important as these gaps provide secondary air to the unit.
A tip to stop any burn media going into the gaps is to place the installation guide in the burner
gap while placing the vermiculite or crushed glass over the burner.
Quantity
1 bag (approx. 0.75 L)
1 bag (approx. 3 g)
4 logs and 9 stones
1
3 logs
Quantity
3 bags (approx. 3.5 kg)
1 bag (approx. 3 g)
Linear 1500 burn media installation: 13570-C | 1