Table of Contents
Advertisement
NA380 Motherboard
Hard Disk Drive
NOTE: If installing two IDE devices on the same ribbon cable, one
1. Mount the drive into the case.
2. Connect the IDE disk ribbon cable and power cable to the IDE device.
3. Connect the IDE ribbon cable to the motherboard IDE connector
IDE1 or IDE2 (refer to the previous section "Connecting IDE and
Floppy Disk Cables").
IDE Ribbon Cable
NOTE: If you are installing a CD-ROM or DVD-ROM IDE device,
device is to be set as "master" and the second as "slave".
Refer to IDE device manual for master and slave settings.
connect the audio cable supplied with the device to CDIN1
or CDIN2.
13
Power
Cable
Advertisement
Table of Contents
