Okina USA LPC Series Operational Manual

License plate capture day & night camera

Advertisement

SHM-7540LPDN-IO
SHM-7540LPDN-IOP
Operational Manual
License Plate Capture Series
License Plate Capture Day & Night Camera

FEATURES

1/3" Sony Super HAD CCD II
Sony HQ-1 DSP, 540 TVL
0.08 Lux @ F1.0
I/O Input/Output
Mechanical IR Cut Filter (ICR)
Built-in Auto Sens-up
High Gain/Low Noise Amplifier - DNR
Advanced 8-step Manual Shutter
CAR-DC Iris Control is available to achieve reliable license
plate recognition for road surveillance when car speed is up
to 90 mi/hr (150km/hr) in the daytime and 90 mi/hr
(150km/hr) at night time with external IR LEDs.
Dual Power 12V DC / 24V AC

DIMENSIONS (Unit: mm)

PARTS AND FUNCTIONS

Copyright © 2009. All Rights Reserved.
www.okinausa.com
Please read the Operational Manual
before attempting to use this product.
Note: Do Not Remove Screws
Lens Mount
1
This mount is used to install a CS mount lens.
CS adaptor ring is required if using a C mount lens.
2 CS Mount Fixing Screw
Screw for fixing mount and adjusting back focus if needed.
3 Mount Adaptor
This adaptor can be attached to either the top or bottom of unit.
4 Auto Iris Lens Connector (4-pin type)
The lens connector supplies the auto-iris lens (not supplied) with
DC power and a video signal or DC control signal.
5 ME/AES Shutter Control
(0) 1/100 (120) sec.
(2) 1/350 sec.
(4) 1/1120 sec.
(6) 1/3240 sec.
Camera to object moving speed
Shutter
45~60ft
Speed
(15~20m)
1/100 sec
1/190 sec
1/350 sec
15~35 mi/hr
1/610 sec
(30~60 Km/hr)
20~40 mi/hr
1/1120 sec
(35~65 Km/hr)
25~45 mi/hr
1/2000 sec
(45~75 Km/hr)
30~50 mi/hr
1/3240 sec
(50~80 Km/hr)
35~55 mi/hr
1/4000 sec
(60~90 Km/hr)
*The table above is only for reference. Values may change due to the angle
of the camera and the installation location.
6 Control Switch
SW1. BLC: Backlight Compensation OFF/BLC switch
SW2. Day/Night Mode: D/N / Color switch
SW3. AGC: Automatic Gain Control AGC/S.AGC switch
SW4. Sync Mode: Sync Mode Selection L.L/INT switch
7 Video Connector
Output for connecting to a video monitor or recorder.
8 Auto Iris Mode Selection Switch
For switching the output from the auto iris connector. Shutter
speed is fixed at 1/100(120) sec. when switch is set to DC or
VIDEO position.
DC: To be set when using a auto iris lens. Be sure to
adjust proper DC level for D&N operation.
CAR-DC: To be set when using for license plate
capture. (Car speed is up to 90 mi/hr (150 km/hr) in the daytime
and 90 mi/hr (150 km/hr) at night with external IR LEDs).
VIDEO: To be set when using an auto iris lens with built-in amp.
(1) 1/190 sec.
(3) 1/610 sec.
(5) 1/2000 sec.
(7) 1/4000 sec.
60~100ft
100~180ft
(20~35m)
(35~60m)
45~45 mi/hr
(45~75 Km/hr)
35~53 mi/hr
(55~85 Km/hr)
40~60 mi/hr
(65~95 Km/hr)
50~62 mi/hr
50~62 mi/hr
(80~100 Km/hr)
(80~100 Km/hr)
55~65 mi/hr
55~65 mi/hr
(90~105 Km/hr)
(90~105 Km/hr)
P = PAL Version
2
REV092909

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LPC Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Okina USA LPC Series

  • Page 1 SHM-7540LPDN-IO SHM-7540LPDN-IOP Operational Manual License Plate Capture Series License Plate Capture Day & Night Camera Lens Mount This mount is used to install a CS mount lens. CS adaptor ring is required if using a C mount lens. 2 CS Mount Fixing Screw Screw for fixing mount and adjusting back focus if needed.
  • Page 2 9 V.P. (Vertical Phase) Adjustor For Highway Surveillance: Used to adjust the vertical phase of the video output signal Power Input Terminal Connect the power supply of 12V DC or 24V AC. CONTROL SWITCH OPERATION ME/AES Shutter Control should be set on “3” or “4”. SW1.
  • Page 3 LIST OF COMPONENTS WARRANTY One (1) SHM-7540LPDN-IO/SHM-7540LPDN-IOP Camera OKINA USA products are covered under warranty for one year from One (1) Operational Manual the date of purchase. The warranty will automatically be voided if any of the following occurs: * For any returns, please include all components listed above with original packaging in Resalable Condition.

This manual is also suitable for:

Shm-7540lpdn-ioShm-7540lpdn-iop

Table of Contents