COX Homelife Smart LED Light Bulb Installation & Pairing Instructions

With the Smart LED Light Bulb from Homelife, you can easily switch out old bulbs,
for new efficient, dimmable LED bulbs that have a life expectancy of up to 22 years!
Plus, you can control your lights remotely using the Cox Homelife mobile app or
online Subscriber Portal, and set up Rules that automate when they turn on or off.
Follow these steps to install and pair your new Smart Bulb with the Homelife system.
Expected Installation Time: 5 minutes
1
Watch Installation Video
Before you begin, watch the Smart LED Light Bulb installation
video at cox.com/diyhomelife
2
Install Smart Bulb
You may install your Smart Bulb in any indoor light fixture, such a lamp
or ceiling light, with an E26 standard (medium) base socket.
1. Start with the light turned off
2. Replace the old light bulb with the new Smart Bulb
3. Turn on the light
The light bulb will begin to pulse, indicating it is ready to pair with your
Homelife system. You will have 3 minutes to complete the pairing
process.
TROUBLESHOOTING TIP
If the bulb does not pulse immediately, or if it has timed out, you can
reset it by pressing and holding the bulb's power button located on
the side of the bulb, while installed and the light turned on. Press the
button for 20 seconds, then release. The bulb will blink five times
and then begin to pulse, indicating it is ready to pair.
3
Pair Smart Bulb with Touchscreen
1. On your Touchscreen Control Panel, press the Settings
2. Enter your 4-digit master keypad code.
3. From the Settings menu, select Home Devices > Lighting > Add
Lights.
4. The Locating Lighting Devices screen will appear. Press Next to
begin the pairing process. Once the Smart Bulb is found by the
Touchscreen, the light will become solid.
(Note: Do not press Done during the pairing process.)
5. When the "Dimmable Light"
complete. Press Done. Then press Next to configure your Smart Bulb.
on your mobile device, tablet or
icon appears, pairing is
Smart LED Light Bulb
Installation & Pairing Instructions
cox.com/diyhomelife
computer.
INSTALLATION TIP
Pair the bulb using a lamp located
near your Touchscreen. You can
move the bulb to any location
after pairing is complete.
Power
button
app.
Step 5: Press Done after pairing is complete
START HERE
Continued on next page...