Related Manuals for Plumbworld IN00050
Summary of Contents for Plumbworld IN00050
- Page 1 IN00050 (rev D) Two Panel Sliding Bath Screen • Instruction suitable for both Right and Left Hand Fixing...
- Page 2 Before You Start • Check that the bath has been installed correctly and that it is level (Fig. A), tiled down onto and Fig.A. sealed to the manufacturerʼs guidelines. Please Note: All product supplied without bath. • Check that there is suffi cient space on the bath for the product and that the screen movement does not foul other items such as sinks and taps.
- Page 3 Parts & Fittings Supplied Please notify the retailer immediately of any damage or faults. The manufacturer cannot be held responsible for any installation costs that may arise from a damaged or Keep small parts away from children faulty product being installed. Bath Screen Assembly Oversized Horizontal Seal...
- Page 4 Wall Channel Loose Screws & Fittings Supplied No.8 x 1” Pan Head Pozi Screws (actual size) Wall Plugs (actual size) No.8 x ⅜” Pan Head Pozi Screws (actual size) Screw Cover Caps (actual size)
- Page 5 Horizontal Seal Preparation Cut Horizontal Seal in to 2 pieces. Apply to 1 cut down seal only. iii)
- Page 6 Inside View Remove cover cap Slide Horizontal Inside View Seal into position Tie end of seal into tight knot Pull seal back to remove any slack Trim Horizontal Seal overlap Replace cover cap...
- Page 7 Inside View Inside View Remove cover cap Slide Horizontal Seal into position Trim Horizontal Seal overlap Replace cover cap...
- Page 8 Tip: When drilling tiles apply masking tape to surface to stop drill bit slipping. Wall plugs supplied are for solid Mark position walls only. Ensure correct wall plug pre-drilled Wall for wall type is used. If in doubt seek Channel holes professional advice.
- Page 9 BATH OUTSIDE SIDE FACE Please Note: Ensure Horizontal Seal sits on top of bath. Inside View Inside View * 3mm dia. holes through pre-drilled wall channel holes using HSS drill bit 5.1*...
- Page 10 Apply a small amount of Silicone Grease from sachet (supplied) to the hinge mouldings. Apply Silicone Sealant, (not supplied). Only apply sealant to the outside of the Bath Screen. DO NOT use silicone sealant on inside of the Bath Screen. Product Care: Use a non abrasive cleaner.
- Page 11 Notes:...
- Page 12 Notes:...
- Page 13 Check out our full range of Shower Enclosures Quadrant Shower Enclosures Corner Entry Shower Enclosures Walk in Shower Enclosures Sliding Shower Doors Bifold Shower Doors Pivot Shower Doors Hinged Shower Doors Shower Screens From Top Brands Coram Shower Enclosures Mira Shower Enclosures Hydrolux Shower Enclosures Diamond Shower Enclosures With quality shower trays to match your enclosure...
Need help?
Do you have a question about the IN00050 and is the answer not in the manual?
Questions and answers