Important Notes Thank you for choosing A.O. Smith Air Purifier. To optimize the performance of the air purifier, please read and follow this instruction manual. Also please keep this manual in a safe place for future reference. 1. For the initial operation or after replacement of filters, please remove the packing of filers according to the instruction.
Packing List Item Unit Note Air Purifier ― Instruction Manual ― Sensor Filter 1 piece has been pre-installed in factory, 1 piece included as gift. Plastic Mesh Filter Have been pre-installed in factory. Pre-filters 2 pieces have been pre-installed in factory, 2 pieces included as gift. Main-filters Have been placed inside the unit, remove packing before operate.
Page 6
Main-filters installation (Remove the Mesh/Pre-filter set beforehand) Installation Direction Main-filter Main-filter Handle 1 Disconnect the power supply & 2 After the packing of Main-filter is being 3 After all filters are installed, close make sure wheels removed. Install Main-filter with the back cover, turn on the unit and unlocked.
Operation Instructions Control Panel of Air Purifier Filters Position Indicator Main-Filter Lifespan Indicator PM2.5 Pollution Gas Pollution Monitor Monitor & Meter Pre-Filter Lifespan Sensor Filter Lifespan Indicator Indicator Wind Speed Monitor (Off Timer Indicator) To Operate______ A “beep” will be heard and the will light up after the plug is connected to the power.
Page 8
Note: The sensors will initialize after the first time of the unit is being connected to the power supply; or being turned on again after the unit is not in used for a period of time. The process of initialization will take 2-5 minutes to complete.
Wheels Lock 1 Step down the lock lever as shown above 2 Release the rotatable wheels by lifting to secure the rotatable wheels. up the lock lever when the unit is needed to be moved. Maintenance Caution: The power plug must be unplugged before cleaning or maintenance the unit. ...
Page 10
Replace Sensor Filter Note:The sensor filter has been pre-installed in factory; no installation is needed for the initial operation. Sensor Filter Cartridge Indicators Reset Instruction & Reset Buttons 1 Disconnect the power supply & make sure wheels are 2 Pull out the cartridge to replace filter as shown unlocked.
Page 11
3. Plastic Mesh Filter The Plastic Mesh Filter can be washed with water, suggest washing it once every two months. After the Plastic Mesh Filter is being washed, please air dry the filter in a well ventilated environment before it is installed to the unit.
Page 12
Reset Main/Pre-filter Lifespan Indicator After a filter has been replaced, the corresponding lifespan indicator has to be reset immediately. Please refer to the indicator reset instruction. Pre/Main-filter Locator Reset buttons and the corresponding filters Please replace filter according to the instruction. When a filter is replaced, turn on the unit and reset the corresponding filter lifespan indicator immediately.
Troubleshoot 1. Problems caused by abnormal use or environment: Symptoms Possible Cause Solution Is the power supply normal? Check power supply Is the power plug plugged properly? Check power plug No wind from the unit Are the packing of filters not been removed? Check main/pre-filters Is any object blocking the air in/outlet? Remove the object...
3. Application for one year warranty must be completed and returned to A.O. Smith Hong Kong via fax, e-mail, or post, within 14 days of purchase. The warranty will become effective after the receipt of the application, without any confirmation notice or written documents in return.
Page 15
此頁特意留空/This page is intentionally left blank.
Page 16
此頁特意留空/This page is intentionally left blank.