Download Print this page

Panasonic TX-47PT10 Service Manual page 4

Euro-7vp chassis
Hide thumbs Also See for TX-47PT10:

Advertisement

HOW TO MOVE THE CHASSIS INTO SERVICE POSITION
1.
Remove the PCB clamp (A) located between chassis and DG PCB as shown in Fig1.
2.
Remove the gnd connections to A51 & A52 , also undo all wire dressing clips as shown in Fig2.
3.
Remove shielding connector and the connection to power terminal on P-PCB (P2) as shown in Fig3.
4.
Hold and lift the rear of the chassis and gently pull the chassis towards you , as shown in Fig4.
5.
Remove all connectors connecting away from main chassis and rotate through 90 degrees , vertically
as shown in Fig5.
6.
After servicing replace the PCB clamper (A) and and ensure all wiring is returned to its original position before
returning the receiver to the customer.
Fig1.
GND CONNECTORS
A51 & A52
SHIELDING
EARTH
Fig3.
Fig5.
(A)
CONNECTION
TO P2
Fig2.
Fig4.
4
WIRE
DRESSING

Advertisement

loading