PSI Woodworking Products MLCUTOFF User Manua

Micro pen tube cut off saw

#MLCUTOFF

Micro Pen Tube Cut O Saw

User Manual

The Micro Tube Saw and Sizing Jig is engineered and manufactured to the highest standards of quality. You will nd this product an

essential accessory to your workshop. This saw is warranted against defects in material and workmanship for a period of two years

for all components. This warranty applies to the original purchaser of the product and is limited to the repair and/or

replacement of the product, or its parts at the discretion of PSI Woodworking Products. Excluded are parts which have been mis-

used, abused, altered, or consumed by normal operation of the saw. Also excluded are direct or consequential damages to persons,

properties, or materials. Your invoice serves as proof of purchase and must be referenced to authorize any warranty repair. Call your

PSI dealer for proper authorization.

WARRANTY

PSI Woodworking Products

SPECIFICATIONS

• Power Source: 110VAC, 60HZ, .9AMP

• Blade: HSS 2" dia, .020" Thick

• Max RPM: 7800, Arbor 3/8"

Read Manual before operating

• Copy any pen tube exact length

• Ideal for quickly cutting single or

multiple pen tubes

• Integrated ruler for sizing

Table of Contents

Do you have a question about the MLCUTOFF and is the answer not in the manual?

Page 1 This warranty applies to the original purchaser of the product and is limited to the repair and/or replacement of the product, or its parts at the discretion of PSI Woodworking Products. Excluded are parts which have been mis- used, abused, altered, or consumed by normal operation of the saw.
Page 2 PSI Woodworking Products #MLCUTOFF GENERAL & SPECIFIC SAFETY RULES 1. KEEP GUARDS IN PLACE and in working order 2. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents 3. DON’T USE IN DANGEROUS ENVIRONMENT. Don’t use power tools in damp or wet locations or expose them to rain. Keep work area well lit.
Page 3 PSI Woodworking Products #MLCUTOFF UNBOXING: SPECIFICATIONS: • Saw and Table Unit come pre-assembled. Tube Holder should be attached per Assembly instructions below prior to use. Saw and Table Unit Check contents for accuracy (Pre-assembled) immediately upon receipt. • Guide Ruler measures from the Blade ascending to the right and left.
Page 4 #MLCUTOFF PSI Woodworking Products SETTING THE FLIP STOP FOR MEASURING: When measuring, the Stop must be down. • Flip Stop can be set using a sample tube, Guide Ruler, or the locked jaws of digital calipers (see pictures below) •...