Mounting The Chuck Using The Asr Eurolock Locking Ring - Teknatool nova PRO-TEK SUPERNOVA2 Operation Manual

Mounting the chuck using the ASR Eurolock locking ring

The M33 version NOVA lathes and chucks have a special locking coupler to prevent
the chucks from coming loose and detaching from the lathe spindle. The ASR Eurolock
locking ring is exclusive to the M33 version lathes and chucks.
Note:
The locking ring is not compatible with lathes and chucks that are not the M33 ASR
Eurolock model.
Below are the steps on how to attach the EU
locking ring:
Step 1:
Tighten the EU chuck to the spindle on the
lathe, make sure the rings on the spindle and
chuck have been clamped.
Step 2:
Put the lower part of locking ring under the
clamped rings.
Step 3:
Put upper part of the locking ring to the
clamped rings as well.
Step 4:
Using the Hex key to tighten up two bolts on
the locking ring.
17