Advertisement
Bodypack GXLIEMBP Receiver
1. Antennas
2. LCD display
3. IR Node
4. Battery compartment
5. Power switch and volume control
6. Earphone jack
7.
Line out jack
8. Belt clip
9. RF Signal indicator
10. Low battery indicator
(flashes when low)
T Band 902-928MHz
CH
MHz
0
903.250
1
903.825
2
904.875
3
905.325
4
905.975
5
906.575
6
907.225
7
908.425
8
909.075
9
910.875
A
911.325
B
916.850
C
925.000
D
925.650
E
926.850
F
927.650
6
5
6
7
8
1
9
10
2
3
4
Operating Instructions/System Setup
1. Apply power and press the power switch. The following screen
appears at power up.
Fb = Frequency Band
90 = 902 - 928MHz
2. Default display shows current transmitting channel.
Setting the transmitter frequency
3. Channel adjustment. A long press of the UP and DOWN button
unlocks channel adjustment.
When the channel numbers are
flashing, press the UP or DOWN
button to select a channel.
Setting the bodypack receiver frequency
4. ScanLink™ is enabled by pressing
the DOWN and UP buttons
POWE R
simultaneously for one second.
Hold the receiver ScanLink interface
towards the flashing LED to set
receiver frequency.
Should you need to temporarily turn off the transmitter
Transmitter power enable/disable.
Transmitter power can be
temporarily disabled by holding
the DOWN and UP buttons for more
than 3 seconds until the screen to
the right appears. To enable, hold
both the DOWN and UP buttons
at the same time until default interface appears.
IR
ScanLink
3
Advertisement
