BEMIS bioBidet USPA 6800U Owner's Manual page 12

OPERATION (CONT.)
User Setting
•
Each button can save 2 settings. (Cleansing, Bidet)
•
Press the User 1 button and Cleansing or Bidet consecutively. Then
choose nozzle position by pressing the FRONT/REAR button and water
pressure level by pressing the LOW/HIGH button. Press User 1 again will
save the setting with a beep.
•
The same applies to saving the User 2 setting.
•
Press User 1 or User 2 while using cleansing or bidet to
operate saved settings.
Side Control Buttons
•
Use side control buttons on the unit when the remote control is
broken or its batteries are dead.
•
Press "cleansing" on the right side or "Bidet" on the left side to start.
•
Press again to stop. Do not press buttons with sharp-edged items.
22
Identification
•
This function is useful for public toilets when more
than one unit of this product is installed.
•
To prevent interference among units, the main unit and
remote control should be set with the same ID.
•
If there is only one unit in the bathroom, you do not need to set the ID.
•
The initial ID of theremote and main unit is "0".
There are 16 choices in ID (00~15).
How to Set ID (Remote Control)
•
Press the "High" button for 3 seconds and ID will show
up in the display.
•
Press the "High" or "Low"
in the display. (00~15)
•
Press "Stop" to save the ID.
button until your ID appears
23