Fig. 21: Lifting electrical motor vertically
4. Mount the electric motor in the Drive Unit
Lift the electric motor on to the Drive Unit. It is important that the electric
motor is hanging vertically. Fit the shaft coupling through inspection hole (Fig.
22) into the ring gear coupling without causing any damage. Lower the motor to
a position approximately 5 mm (0,2 in) above the bellhousing. Place screws in
the holes and tighten by hand. Lower the motor to the bellhousing.
Installation | Hägglunds DUc Drive unit
RE 15326-WA, Version 06.2020, Bosch Rexroth AB
35/88
DD00098773