Connecting Water Supply; Connecting To The Drain - Beko WDB7425R2W User Manual

C
INFORMATION
• Keep the transit bolts in a safe place
to reuse when the product needs
to be moved again in the future.
• Never move the product without the
transit bolts properly fixed in place!

3.4 Connecting water supply

C
INFORMATION
• It is necessary to have 10 – 80 liters of
water flowing from the fully open tap in
one minute to have your product run
smoothly. Attach a pressure reducing
valve if water pressure is higher.
A
CAUTION!
• Models with a single water inlet should
not be connected to the hot water
tap. In such a case the laundry will get
damaged or the product will switch to
protection mode and will not operate.
12 / EN
1
1 Use a tool to
loosen all bolts until
they rotate freely.
2
2 Remove the transit
bolts by turning
them slightly.
3
3 Attach the plastic
covers supplied in
the user manual
bag into the holes
on the rear panel.
1
1
2
A
CAUTION!
3
• Ensure that the cold water connection
is made correctly when installing the
product. Otherwise, your laundry
will come out hot at the end of the
washing process and wear out.
1
2
If any leak occurs, turn off the tap and
remove the nut. Retighten the nut carefully
after checking the seal. In order to prevent
the water leaks, keep the taps closed
when you do not use the product.

3.5 Connecting to the drain

• Attach the end of the drain hose directly
to waste water drain, sink or bathtub.
A
CAUTION!
• Your house will be flooded if the hose
comes out of its housing during water
discharge. Moreover, there is risk of
scalding due to high washing temperatures!
To prevent such situations and to ensure
smooth water intake and discharge of
the machine, fix the end of the discharge
hose tightly so that it cannot displace.
2
3
1 Connect the special
hose supplied
with the product
to the water inlet
on the product.
2
2 Tighten the hose
nuts securely
by hand. Never
use a tool when
tightening the nuts.
3 Open the taps
3
completely after
making the hose
connection to
check for water
leaks at the
connection points.
Washer-Dryer / User's Manual
3