Advertisement
5. assEmbly
note:
numbers in brackets refer to item numbers shown in the parts diagram.
5.1.
Insert the telescopic beam (6) into the beam (15) and secure using the grip (10).
5.2.
Remove the grip (4) and washer (5) from the standing block (7), pass the threaded section of the standing block through the hole in
the telescopic beam (6) and secure using the washer (5) and grip (4).
5.3.
Remove the bolt and locknut (9) from the standing block (7), insert the foot assembly (11) and secure using the bolt and locknut (9).
5.4.
Repeat paragraphs 5.1 to 5.3 at the other end of the beam (15).
5.5.
Slot the threaded section of the adjustable screw (13) up through the centre hole in the beam (15), fit the washer (3) and secure using
the operating clamp assembly (2).
5.6.
The engine support is now ready for use.
note:
Ensure all grips and nuts are tightened before applying a load.
6. opEration
note:
numbers in brackets refer to item numbers shown in the parts diagram.
6.1.
ensure the adjustable screw (13) is wound to its highest position to prevent damage whilst locating
the engine support over an engine bay.
6.2.
ensure the grips (4 & 10) are loose and locate the rubber blocks (12) in the gutters of the vehicle's
front wing panels or close to the suspension strut towers.
6.3.
Attach the ends of the chain to the lifting brackets on the engine.
note:
Refer to manufacturer's handbook to identify lifting brackets.
6.4.
lower the adjustable screw and hook the chain around the hook as shown in fig.2.
6.5.
Tighten all four grips (4 & 10) and all nuts.
6.6.
Rotate the operating clamp assembly to tighten the chain and support the engine.
6.7.
on completion of the maintenance task, rotate the operating clamp assembly to release the tension
on the chain.
6.8.
Unhook the chain, loosen both grips (4 & 10) and remove the engine support from the vehicle.
6.9.
Remove the chain from the engine lifting points.
EnVironmEnt protEction
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey group, kempson Way, suffolk business park, bury st Edmunds, suffolk. ip32 7ar
01284 757500
© Jack Sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig.2
www.sealey.co.uk
eS500.V2 Issue 4 (HF) 22/08/18
Advertisement
