Advertisement
Quick Links
Advertisement
Summary of Contents for Vigilant 5 Column Soffit and Beardboard Arches
- Page 1 Wine Rack Assembly Instructions Archtops 5,7 &10 Column Soffit and Beardboard Arches...
- Page 2 Congratulations! You have purchased the finest wine racking available anywhere. Properly assembled, these Vigilant wine racks will outlast even your finest wines. Please call toll free 888-812-4427 if you have any questions or problems. Tools Required for Assembly: • Electric drill or cordless screw gun •...
- Page 3 How to Care for Your Stained & Lacquered Arches? • Your Vigilant arches are built using the highest quality Mahogany and finish available. When properly cared for, your wine racks will last longer than your finest bottles of wine. Here are a few tips at maintaining the quality and consistency of your wine racking.
- Page 4 Exploded View of Archtop (slatted shown)
- Page 5 Steps to Assembly Note: Your assembly instructions are the same for a beadboard arch, slatted arch, and arches with pre-installed lighting. If you have an arch with pre-installed lighting, please reference page 10. 1. Locate your two side panels and your top panel (See Parts List). Notice that the side panels come with slats or beadboard edges depending on which type you purchased.
- Page 6 5. Repeat step 3 for the other side panel (Figure 3). Figure 3 6. Repeat step 4 for the other panel (Figure 4). Figure 4...
- Page 7 7. Now that your top is secure, attach the bottom piece. Apply some wood glue to the bottom of your side panels. Set the bottom panel against the side panels as shown in (Figure 5). Align the panel with the back edges as it will overhang the front by ¾". Note: If your arch is being paired with a double deep table then the bottom panel is not used.
- Page 8 9. Carefully stand your archtop upright and check that your assembly has four 90 degree angles. You should have the same measurement if you measure diagonally from corner to corner. If necessary, use a soft-faced hammer to achieve an equal measurement for each diagonal. 10.
- Page 9 The arch is now connected to the transformer and ready for final installation into your wine room. Note: Below are the steps Vigilant took to pre-install the display lighting in your slatted arch. Please use these steps if you need to replace a bulb or bulb holder. Replacing a bulb in your beadboard disk lighting is as simple as removing the diffuser trim, removing the bulb, and replacing it with a new glass wedge bulb.
- Page 10 ESCAPE HOLE FOR WIRE PATH ESCAPE HOLE FOR WIRE PATH Diagram 6 Diagram 7 Soffit Arch Slat & Radius Arch Slat & Escape Hole Locations Escape Hole Locations Step 7 - Connecting the Driver Connect the driver to the assembly and install the switch if desired. Step 8 - Lighting Kit Check Plug the driver into the power source and check that all fixtures properly illuminate.
Need help?
Do you have a question about the 5 Column Soffit and Beardboard Arches and is the answer not in the manual?
Questions and answers