Advertisement
Quick Links
Commissioning
• Re-fit the tubes and the side panels. NOTE: When fitting
the side panels –please make sure that there is a gap
between the side panels and the door as shown. This
gap is required so that the door does not contact, and
damage, the side panels when it is opened. Make sure
that all rubber washers are used under the fixing screws
– to protect the fitting against water ingress and that no
Shaver Socket Instructions
• The shaver socket is powered by a 20W isolating
transformer and is only intended for use with electric
shavers, electric toothbrush chargers and similar
products.
• Any appliance connected to the socket must not exceed
• We recommend cleaning with a soft dry cloth. Do not use
solvents or abrasive cleaners as these could damage the
finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Safety information
Live Voltages may be present in this unit even when turned of or when completely disconnected. For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
The mirror must be replaced immediately should it become cracked or damaged. This fitting must
not be used without the mirror in place.
Replace Cracked Shade
cables are trapped.
• Position the shelves as required. To loosen the shelves,
turn the knurled nuts CLOCKWISE. Move them to the
desired slots then turn them ANTI-CLOCKWISE to secure.
Turn on the power and test the lights (pull cord) and
shaver socket.
the 20W power output as this could cause damage and
overheating to occur.
• Always check your appliance instructions to ensure the
power requirements are less than 20W.
• Mirror – Use a damp cloth or a propriety glass cleaner.
Do not use abrasive materials as these will damage the
finish.
Iss.4 14102016
Endon Lighting LS9 0SE
Instruction leaflet
Milos Mirror
EL-MILOS
(56589)
Advertisement
Related Manuals for Endon EL-MILOS
Summary of Contents for Endon EL-MILOS
- Page 1 Make sure Turn on the power and test the lights (pull cord) and that all rubber washers are used under the fixing screws shaver socket. EL-MILOS (56589) – to protect the fitting against water ingress and that no Shaver Socket Instructions • The shaver socket is powered by a 20W isolating...
- Page 2 Installation Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference. Existing fittings must be completely removed before • Diagram 2: Mark out the 4 mounting positions as installation of a new product. Before removing the existing shown, and determine the position of the cable Warning fitting, carefully note the position of each set of wires. entry. Drill and plug the mounting surface. Bring the mains cable through the rubber grommet in the back • Diagram 1: Make sure that the shelves / brackets are housing and secure the back housing to the mounting This is a Class 1 product and must be earthed This light fitting should be connected to a fused circuit. kept in a safe position until required. Remove the mirror surface – making sure that the sides are vertical and Please read these instructions carefully before If replacing an existing fitting, make a careful note of the side panels by removing the 4 side screw assemblies the top is horizontal. NOTE: The rubber grommet commencing any work.
Need help?
Do you have a question about the EL-MILOS and is the answer not in the manual?
Questions and answers