Advertisement
Quick Links
Single Door Quadrant
ASSEMBLY GUIDE
1.. The cubicle can be constructed either way up, for left or right hand opening.
2.. These instruction and list of parts assume that installation is done against solid or tiled walls. Hollow or
"Stud - partition" walls will require alternatie fixings. Please consult a hardware supplier for the correct type.
It may also be necessary to consult your tiling supplier about the correct method for drilling your tiles.
3.. Please check this product for damage prior to starting the installation. No claims can be made after the
products has been fitted, or after fitting has commenced.
4.. This is a 2 person installation.
5.. Please note the minimum and maximum adjustment for this product are based on perfectly plumb walls.
Please note hand tools NOT supplied.
Spirit Level
7mm Masonry Drill
PH2 TYPE
Drill
3.2mm HSS Drill
Pencil
Tape Measure
Sealant Gun
Screwdriver
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for SOMMER Single Door Quadrant
- Page 1 Single Door Quadrant ASSEMBLY GUIDE 1.. The cubicle can be constructed either way up, for left or right hand opening. 2.. These instruction and list of parts assume that installation is done against solid or tiled walls. Hollow or “Stud - partition” walls will require alternatie fixings. Please consult a hardware supplier for the correct type.
- Page 2 EXPOLDED VIEW AND PARTS LIST Part List SN CODE Description Qty Image SN CODE Description Qty Image 1 ALU8654 Wall channel S1PS22 Roller Stopper 2 ALU8656 Horizontal profile SBLTL002 ST3.5*8 Screw 3 N/M Door Panel 13 S1HW64 Top Runner 4 N/M Fixed Panel 14 S1HW65 Bottom Runner...
- Page 3 TRAY MUST BE SEALED FULLY AROUND WHERE THE TRAY MEETS THE WALL TRAY MUST BE 100% LEVEL IN ALL DIRECTIONS TRAY MUST BE 100% LEVEL IN ALL DIRECTIONS TRAY MUST BE SEALED FULLY AROUND WHERE THE TRAY MEETS THE WALL Ensure the shower tray is level in all directions and is properly sealed to the wall.
- Page 4 Step C Put a small amount of silicone in the corner between the glass and the profile where the glass clips are fixed to the top and bottom profile. Then tighten the glass clips with screws as Fig.C shown, and put the glass clip caps on.
- Page 5 Step F Fix the wall channel with screw cover cup S1PS07 and screw ST4x30 SBLTL013 to wall. Step G Install the top and bottom rollers S1HW64 / S1HW65 to the top and bottom holes of the moving panel. See G.1 Slot rollers into the top profile and then clip in the bottom rollers as shown in G.3, G.4 and G.5.
- Page 6 Step K Put the upright profile cap S1PS05 and wall channel cap S1PS04L/R on. 24 HRS DO NOT USE THE ENCLOSURE FOR BLEACH WHITE 24 HOURS AFTER SPIRIT SEALING Step L Applying Silicone Sealant And Cleaning Seal from the top of the wall channel to the bottom on the INSIDE and Outside between the wall channel and the wall, and between the bottom profile and shower tray as shown.
Need help?
Do you have a question about the Single Door Quadrant and is the answer not in the manual?
Questions and answers