cascade corporation Palm 6030844 Setup Instructions

c
Setup
Instructions
Follow the steps below to use a Palm
set up Force Control products. (Acceptable Models M125,
M130, Tungsten T2, T3, W, C, Zire 71.)
CAUTION: Keep Palm on charger when not in use. Com-
munications software will be lost if battery runs down. See
instructions on next page to configure ptelnet
required.
1
Connect the Palm to the system controller pigtail using
the Cascade adapter cable.
2
Turn the Palm on and tap the 'Home' icon to see the
Cascade page with ptelnet communications application
('computer screen' icon).
3
Tap the ptelnet icon.
4
Tap the On button on menu bar that appears across
bottom of screen ('On' button highlights and blinking
cursor appears):
On tl Esc Kbd VT
5
Cycle the truck key ON/OFF, then ON. Palm screen may
show words 'arm movement'.
6
Press the Enter key (Palm 'squiggly line' note pad key on
RH side of Palm). Words 'arm movement' may appear.
7
Press the Enter key again and follow the Force Control
prompts on-screen.
IMPORTANT: Enter key ('note pad' icon) is used for all
setup procedures when using the Palm. Use to cycle
through Force Control menus and to return to main menu.
8
™
Use the Graffiti writing area to enter data with the stylus
(preferred method) then press the Enter key.
9
An alternate method of entering data uses the on-
screen keyboards shown opposite. Press the on-
screen Done button first, before pressing the Enter
key.
IMPORTANT: If the Enter key is pressed before the
on-screen Done button, the steps must be reentered.
It is not possible to back up in an AFC step or menu.
1
ptelnet V 0.6 shareware: Marcio Migueletto de Andrade at mmand@net.em.com.br.
For more information refer to Palm documentation 'Getting Started' and 'Read This First'.
cascade
corporation
For Technical Support . . .
Call: 1-800-227-2233 Fax: 1-888-329-8207
Internet: www.cascorp.com
Write: Cascade Corporation, PO Box 20187, Portland, OR 97294
™ handheld computer to
1
software if
ptelnet
(Communications
Application)
¥
Macros
AC0730.ill
w e r t y u i o p
a s d f g h j k l ; "
cap z
shift
Done
To Order Parts . . .
Call: 1-888-227-2233
Internet: www.cascorp.com
Write: Cascade Corporation, 2501 Sheridan Ave., Springfield, OH 45505
™
Palm Setup Kit 6030844
for Force Control Products
On-Off
3
10:08 am
telnet telnet
Home (All
Applications)
2
AC0727.ill
Adapter Cable
(connect to
Force Control
controller pigtal)
x c v b n m , .
space - /
abc 123 IntÕl
AC0728.ill
Fax: 1-888-329-0234
2
Menu
Pull-Down
Cascade
8
'Graffiti'
Writing
Area
9
Keyboard
Icons
Enter
('Note Pad' Key)
6,7
1 2 3
£ ´ - +
4 5 6
[ ] ( ) / * :
7 8 9
< > / = . ,
( 0 )
@ ~ & # space %
Done abc 123 IntÕl
AC0729.ill
Part No. 6030841 R-4