Advertisement
Congratulations on purchasing a quality ProBasics
in-One Commode. Our commodes have a versatile design
that can be used as a bedside commode, raised toilet seat or
toilet safety frame. Please be sure to read these instructions
and warnings thoroughly and follow the instructions of your
your safety.
DO NOT ATTEMPT TO ADJUST OR OPERATE
THIS COMMODE WITHOUT READING ALL
ASSEMBLY INSTRUCTIONS
Remove the three-in-one commode components from all
packaging including tape, cardboard and plastic. Check
all parts for damage before use. If any parts are missing or
damaged,
DO NOT
do not understand the manual, contact your dealer for a
complete explanation of the instructions, cautions and
warnings. Otherwise injury may result.
NOTE:
DO NOT
SETUP INSTRUCTIONS
1. Remove frame, seat, lid, pail, cover and splash shield from
carton. Allow the seat and lid to reach room temperature
if exposed to cold. This will help prevent the seat and
lid clamps from cracking while being assembled onto
commode back frame rail.
2. Align the toilet seat clamps onto the back-frame rail (both
clamps should sit outside the pail brackets). Push down on
3. Repeat the same process for the lid, ensuring the lid clamps
line up outside of the seat clamps.
4. Lift the seat and lid to rest against the backrest.
5. Place the commode pail between the pail brackets on the
Remove the bucket lid before use.
ADJUST COMMODE HEIGHT
1. Depress the height adjustment button and slide the lower
leg upward or downward until the height adjustment
button is fully engaged in the desired hole.
2. Repeat for other three leg attachments.
CAUTION:
Ensure that all four commode legs are adjusted to
the same height, and that all height adjustment buttons
protrude fully through adjustment holes before use.
INSTRUCTIONS CAREFULLY.
attempt to use the commode. If you
use excessive force when installing any parts.
Three-
®
3
Advertisement
