Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Zenit Powertools CS-1800 PROFI
- Page 1 InstructIon manual...
-
Page 3: General Safety Precautions
General safety precautions WARNING! When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury, including the following. Read all these instructions before operating this product and save these instructions. For safe operations: 1. - Page 4 19. Stay alert. Watch what you are doing. Use common sense. Do not operate tool when you are tired. 20. Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function.
- Page 5 an uncontrolled saw to lift up and out of the workpiece toward the operator; when the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back toward the operator; •...
-
Page 6: Technical Specifications
9. Bottom protective cover; 10. Abutting platform; 11. Lever of the bottom protective cover; 12. Dust hose; 13. Supporting handle. technical specifications Model CS-1800 profi Rated power 1800 W Rated voltage 220-240 V Rated frequency 50-60 Hz No-load blade speed... - Page 7 specified on the product nameplate. 2. «On\Off» switch. Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the power switch is in the ON position, the power tool will start operating immediately, inviting serious accident. 3.
-
Page 8: Cutting Procedures
Parallelism may be disturb if cutting depth will be adjusted after adjusting parallelism. Never unscrew the sleeve screws. cuttinG proceDures 1. Place the saw body (base) on the work piece, and align the intended line of cut with the saw blade, using the notch at the front of the base. This relationship of base to work pieces should remain unchanged regardless of the inclination of the base. - Page 9 malfunction, sharpen or replace the saw blade as soon as abrasion is noted. 2. Inspecting the mounting screws. Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the screws be loose, retighten them immediately. Failure to do so could result in serious hazard.
- Page 10 Demix LLC Head office: 14, Shevchenko str., 3rd floor Dnepropetrovsk, Ukraine, 49044 tel./fax: +38 056 375-43-16 http://www.en.zenit-profi.com...