Audioplex IRB-4 Installation Manual

Connectors:
Emitter outputs:
Power supply:
Dimensions:
Extra Emitter Jack:
The IRB-4 provides a convenient connecting point for a remote relay system, eliminating hard-wiring.
Multiple IRTargets can be connected in parallel (up to 12) to the screw-down connector. We recommend
running 4-conductor "home-runs" from each room to the equipment stack and either connect directly to the
IRB-4 or use our IR-TB termination block as shown in the wiring diagram below. Each emitter and the
power supply have their own plug-in jacks. Additional emitters can be used from the auxiliary emitter jack.
Utilizing the Audioplex IRS-1, up to (4) additional hard wired emitters can be used. Follow the wiring
diagram below for basic set up. Note that if using IRTargets with System Status, the SYS-TAT power supply
should be plugged into a switched outlet on your A/V receiver.
OPTIONAL
SYS-TAT 12 VDC
POWER SUPPLY
In-wall IRTarget
+12V
GND
STATUS
SIGNAL
Stealth Sensor
StealthX40-HW
INSTALLATION MANUAL
TECHNOLOGY
Termination block for IR repeating systems
TO BE USED WITH AUDIOPLEX BRAND IR ONLY!

SPECIFICATIONS

Screw-type
(4) 1/8" mono mini-jacks
+12vdc unregulated power supply
3.071"H x 1.654"W x .787"D
Allows for an extra Emitter (or 4 extra emitters using the Audioplex IRS-1).

INSTALLATION

12 VDC
POWER
SUPPLY
12VDC
+12V
GND
STATUS
IR IN
EMITTERS
IRS-1
IRB-4
WIRING DIAGRAM
disc 5
tape b
DVD
out to additional controlled components
CALL
1-800-257-2077
TOLL-FREE
2.53
DOLBY DIGITAL
2006 - 4/10/06