Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for S&P ARMO Power Pump
- Page 1 Instructions for commissioning S&P ARMO Power Pump...
- Page 2 S&P ARMO Power Pump construction a) bag version manual filling into top mixer b) silo version / connective automatic filling from silo to top mixer (dust free) power supply 380 Volt / 32 Ampere VER01/11.06.2014/ISM Anleitung für Inbetriebnahme S&P ARMO PUMP – Seite 2/6...
- Page 3 Connect the compressed air and the water to the ARMO-Power Pump. Air and water pressure maximum 2 bar (29 PSI). water Turn main power switch ON. I/ON Push system power switch Light indicator (water pressure) will light light on red. Turn knob to left to reset.
- Page 4 Hold green button to make water flow. Adjust handle to get water flow between push and 420 and 470 l/h on cylinder. hold turn to adjust Turn top mixer clockwise. Fill hopper and examine after it flows out to verify consistency.
- Page 5 Switch to “AUTO” and wait for wet hopper to fill to sensor. Top (dry) mixer will automatically turn off. switch to AUTO Turn pump speed knob to 50%. Can adjusted as needed for proper installation. pump speed knob Before starting prime the hose, to avoid / prevent clogging.
- Page 6 turn knob to right Before stopping shooting, turn mixer to “0” and jet all material trough out ensuring button hopper is empty. position 0 Clean hoses and machine. Disconnect hoses and clean each separately. Use water and run ball through at least twice. Measure regarding occupational safety (protective clothing / accident •...
Need help?
Do you have a question about the ARMO Power Pump and is the answer not in the manual?
Questions and answers