Advertisement
Please fasten all screws by hand. Do not use an
electric screwdriver or drill as over tightening is
not recommended.
See instructions on the snib that performs this function in the next section. Also check that the latch moves freely by pressing the end and by turning with the spindle.
On the back of the lock you will see screw buttons which relate to the push buttons on the front of the lock.
To set the numbers for your code, depress and turn the screw button relating to the desired digit 180 degrees so that the
dot is facing inwards (towards the F). If you wish to take a number out of the code, turn the screw button so that the dot
is facing outwards (towards G).
IMPORTANT NOTE: Be sure to check the code on the lock works before fitting/re-fitting the lock and closing the door.
When the lock is coded and you would like to change the code, be sure to turn all screw buttons from the current code in
a clockwise direction 180 degrees (all dots facing outwards) to cancel the original code then set your new one.
Each and every time you wish to unlock your door you must start by pushing the 'C' button.
The snib on the internal block can be used to keep the latch open. Simply turn the lever handle to withdraw the
latch and push the snib to the opposite side.
Applying the template:
1) Tape the template to the door. Make sure that you fold it along the appropriate line.
The back set on the included latch is 60mm.
2) Mark and drill the two 10mm holes and one 13mm hole.
3) Mark a central point on the "center line of latch" on the door edge.
4) Drill a 25mm hole x 85mm deep.
5) Insert the latch into the hole and draw around the face plate.
6) Remove the latch and cut a 3mm rebate so that the face plate will fit flush with the door.
7) Secure the latch with the wood screws.
Please Note:
You will need untighten the screw in the large hole on the
back of your digital lock to change the vertical handle to a
horizontal left or right hand opening.
13mm
&10mm
drill bits
ALL NUMBERS ON
ALL NUMBERS OFF
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Pinnacle IKONIC DSS003
- Page 1 Please Note: You will need untighten the screw in the large hole on the Please fasten all screws by hand. Do not use an back of your digital lock to change the vertical handle to a electric screwdriver or drill as over tightening is horizontal left or right hand opening.
- Page 2 Additions or modifications can compromise the structure and safety of the product. The warranty covers domestic use only and does not apply to commercial applications. This warranty is given by Pinnacle Hardware, ABN 87 614 496 196, 28 Hudson Court, Keysborough Vic 3173, 1800 349 776, Email: support@pinnacle.net.au. Products sold in New Zealand are imported by Bunnings New Zealand.
Need help?
Do you have a question about the IKONIC DSS003 and is the answer not in the manual?
Questions and answers
can you change the backset from 60 to 70mm