Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Alfresco 310-1716
Summary of Contents for Alfresco 310-1716
- Page 1 Assembly Instruction Item#:310-1716 SavE ThESE inSTrucTionS For FuTurE rEFErEncE.
- Page 2 inForMaTion BEFORE YOU BEGIN Before beginning assembly, make sure all parts are present. Compare parts received with the “Parts List.” If any part is missing or damaged, do NOT attempt to assemble the product. Please read and understand this entire manual before attempting to assemble, operate or install this product. GENERAL INFORMATION Your new patio furniture is made from the finest materials available.
- Page 3 PARTS LIST ParT DEScriPTion QuanTiTY Rotary Table Rotary Ring Table Top Long Support Panel Short Support Panel Table Leg harDWarE conTEnTS 8x30mm Stud 6x40mm Bolt/ 6x15mm Bolt Plastic Nut (6mm) Qty: 5 Qty: 4 Qty: 4 (4 for assem + 1 extra) (3 for assem + 1 extra) (3 for assem + 1 extra) Washer/Spring Washer...
- Page 4 ASSEMBLY Step 1 Place the Table Top(C) with the underside facing skywards. Fit the Stud(I) by turning into the 4 points on the underside of Table Top(C) with the Screwdriver(N). Step 2 Fix the Stud(J) to the Table Leg(F) by using Screwdriver (N). Step 3 Next, attach Table Leg(F) to studs on Table Top(C) using Washer, Spring Washer and Nut(K) with Wrench(M) .
- Page 5 ASSEMBLY Step 4 NOTE: To HOLD the legs together in positon, the LEGS SUPPORT PANELS WILL OVERLAP AT ALL 04 (four) CORNERs. First, attach the Leg Support(D/E) with Groove End to the Studs(J) and then attach Support Panel(D/E) without Groove End to Studs(J), together. Then affix the Leg Support(D/E) to the table legs with the Washers, Spring Washers and Nuts(K) using the Wrench(M).
- Page 6 ASSEMBLY Step 5 Put Bolts(G) into the hole on the inner ring of Rotaty Ring(B),then screw nuts(G) on the opposite side and tighten it with Cross Srewdriver(N) and Wrench(M).Note the screw should enter from the large circle of the tapered hole on Rotaty Ring to the small circle Step 6 Turn the Rotaty Ring(B) so that the screw on Rotaty Ring is upward, and then align holes in the outer ring of Rotaty Ring(B) with the hole on the Rotary Table(A).
- Page 7 ASSEMBLY Step 7 Put Rotary Table (A) on Table Top (C) align bolts on Rotary Table with holes on table top,insert Bolts into the holes.Then affix the Rotary Table to the Table Top with the Washers,Spring Washers and Nuts (L) using the Wrench (M).Add Plastic Caps on all bolt ends.Adjust the leg pre-installed Levellers until the Table is level with the ground.
Need help?
Do you have a question about the 310-1716 and is the answer not in the manual?
Questions and answers