Bradley 817 Series Installation

-001 configuration shown. See Bradley's
website for other configurations.
All mounting hardware is supplied by installer and must be appropriate for wall construction. Wall anchors/
backing used must provide adequate support for the intended load requirements.
Grab bars are no stronger than the anchors and walls to which they are attached, and therefore, must be
firmly secured in order to support the intended load requirements. To avoid potential injury, the building
owner or maintenance personnel should remove the grab bar from service if the mounting is not adequately
secured to the wall or if there are any observed product defects.
Personal Protective Equipment (PPE) is required during the installation of this product.
Read this entire installation manual to ensure proper installation. When finished with the installation, file
this manual with the owner or maintenance department. Compliance and conformity to local codes and
ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Product warranties may be found under "Products" on our website at www.bradleycorp.com.
500-377 Rev. A; ECN 18-15-009
© 2018 Bradley
Page 1 of 2 3/20/2018

Installation

Grab Bars -
Exposed Mounting
817, 837 & 857 Series
WARNING
CAUTION
IMPORTANT
P.O. Box 309
Menomonee Falls, WI 53052 USA
800 BRADLEY (800 272 3539)
+1 262 251 6000
bradleycorp.com