Summary of Contents for PAR TAPS Q/IDK Series
- Page 1 Q / IDK Collection Installation Guide Thank you for purchasing this Par Taps product designed and built Ver 20.2 in australia...
- Page 2 • All products are suitable for use with most instantaneous hot water heaters, however are not compatible with gravity-fed water systems. Water Pressure & Temperature: This Par Taps products are to be installed by a Licensed Plumber in accordance with AS/NZS 3500.1 Maximum Water Temperature 80° Celcius...
- Page 3 Handle Direction COLD Safety Note: For your safety, Par Taps spindles are ‘Contra Turn’ designed. Handles should be fitted to turn/open towards the outlet thus preventing potential accidents such as scolding. Wall Offset Min. 55mm Max. 65mm Please Note: For correct fitment, it is essential that there is a 55-65mm space between the face of the noggin...
- Page 4 Wall set on plate Wall Breech Fibre Washer Ceramic Disc Lock Nut Prior to installing ceramic disc assembly make sure the seat surface is clean and smooth otherwise reseat and recheck. Also ensure that lines have been flushed. Ensure that the hot and cold indicators located on the bottom of the Ceramic Disc Assembly (3) are placed in the corresponding side of the breach.
- Page 5 Backplate Dome Handle Outlet Grub Screw Slide the Backplate (5) over the After the handle has been aligned, screw the Brass lock nut (4) onto the ceramic ceramic disc assembly (3) onto the disc assembly (3) and tighten firmly using a finished wall.
- Page 6 Wall set Wall Breech Fibre Washer Ceramic Disc Lock Nut Prior to installing ceramic disc assembly make sure the seat surface is clean and smooth otherwise reseat and recheck. Also ensure that lines have been flushed. Ensure that the hot and cold indicators located on the bottom of the Ceramic Disc Assembly (3) are placed in the corresponding side of the breach.
- Page 7 Backplate Dome Handle Outlet Grub Screw Slide the Backplate (5) over the After the handle has been aligned, screw the Brass lock nut (4) onto the ceramic ceramic disc assembly (3) onto the disc assembly (3) and tighten firmly using a fi...