Advertisement
5.1.3.
Place the wheel flat on the base (1), locating the rim on the stop (B). Position the bead breaker under the rim flange (fig. 1). depending
on the size of the tyre it may be necessary to adjust the height of the bead breaker (7). remove clevis pins (5), reposition bead breaker
to suit the tyre and refit clevis pins. DO NOT forget to replace the locking pins (6).
5.1.4.
Put the tyre bar (10) into the bead breaker handle (4).
5.1.5.
Pull down firmly on the bar and repeat around the rim until the bead is free.
5.1.6.
turn the wheel over and repeat to free the other bead.
Note: When bead breaking on td or tdX wheels the wheel must be horizontal. locate the rim on the base of the tyre changer and
support the opposite side of the wheel with a suitable piece of timber.
5.2.
Tyre removal
5.2.1.
lubricate both tyre beads with an approved rubber lubricant.
5.2.2.
remove the cap (9) and the wheel retaining spider (8) from the pedestal (3).
5.2.3.
Place the wheel onto the stand with the valve stem uppermost and the wheel peg (A) through one of the wheel mounting holes.
5.2.4.
replace the spider (8) and the cap (9) onto the pedestal (3), see fig. 2, and hand tighten the cap.
5.2.5.
insert the flat end of the tyre bar (10) beneath the top bead and press the opposite side of the bead down into the wheel well.
5.2.6. .
lever the bar against the cap (9) and rotate the bead over the rim (fig. 3).
5.2.7.
if a tube is fitted, pull it out.
5.2.8.
Pull the tyre up and repeat the procedure for the lower bead.
5.3.
Tyre fitting
5.3.1.
lubricate both tyre beads with an approved rubber lubricant.
5.3.2.
mount and lock the wheel to the stand as in 5.2.2. to 5.2.4.
5.3.3.
Place the lower bead of the tyre over the wheel rim and insert the fitting head of the tyre bar (10) between the bead and the rim with the
bead on the ledge of the fitting head.
5.3.4.
lever the bar against the cap (9) and rotate the bead over the rim (fig. 4).
5.3.5.
fit a tube if appropriate and then seat the upper bead in the same manner.
Fig.1
Fig.3
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMpORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
Fig.2
Environmental protection
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7Ar
Original Language Version
Fig.4
01284 757500
01284 703534
tc960 | issue 3 (l) 22/12/16
www.sealey.co.uk
Web
sales@sealey.co.uk
Advertisement
