Wall Mounted Reader Installation
This installation guide applies to the following types of readers:
•
B-SS – Smart Single Gang Reader
•
B-BSS – Bluetooth, Smart Single Gang Reader
•
B-BSPS – Bluetooth, Smart, Prox Single Gang Reader
•
B-SK – Smart Single Gang w/Keypad
•
B-BSK – Bluetooth, Smart Single Gang w/Keypad
•
B-BSPK – Bluetooth, Smart, Prox Single Gang w/Keypad
IMPORTANT: For Bluetooth readers, write down the serial
number of the Brivo reader to configure it for Brivo Onair Pass.
1
Install Metal Wall Plate to Single Gang Box
Connect the wall plate to the single gang box using the provided #6 screws. Alternatively, you can use the provided #4 screws in
the four outer holes for other installation requirements. Drywall installations will require molly bolts.
Standard Single
Gang Box
Installation
2
Wire the Cable to the Control Panel
The Following tools will be needed to install
a wall mount reader:
•
•
•
Included:
•
•
Number
7700 Old Georgetown Road, Suite 300 | Bethesda, MD 20814
301.664.5242 | Toll Free 866.692.7486 | www.brivo.com
Phillips Screwdriver
1" (25mm), 1/8" drill bits
T8 Security Torx Bit (optional for increased tamper
detection)
Reader, Backplate, and Wall Plate
(1) #4-40, (1) pin-in-torx
Serial
3
Attach the Reader to the
Wall plate
Align the reader so that the tabs of the base plate
slide into the slots on the wall plate and slide the
reader into position.
Brivo Reader Installation
•
(2) #6 screws
•
(4) #4 screws
Alternative for
situations outside
of a single gang box
installation