Toro 117–1441 Installation Instructions

Spark Arrestor Kit
Kawasaki-Powered Walk-Behind Greensmaster Mowers
Model No. 117–1441
Installation
1
For models with serial
numbers prior to 269999999
No Parts Required
Procedure
1. Remove the muffler guard from the muffler
bracket(s) (Figure 1). Retain the fasteners.
Note: Steps 2 thru 5 are not required unless
the spark arrestor kit is being mounted on any
Greensmaster 500 or a Greensmaster Flex 21 with a
serial number prior to 220000001.
2. Remove the muffler bracket from the engine
(Figure 1). Retain the fasteners.
1
Figure 1
1. Muffler guard
3. Cut off the deflector end of the mounting bracket at
the bend as shown in Figure 2.
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
2
G011628
2. Muffler bracket
Register at www.Toro.com.
1
1. Muffler mounting bracket
4. Remount the muffler bracket to the engine with the
fasteners previously removed.
5. Cut the three connecting tabs allowing the removal
of the knockout plug in the end of the muffler guard
(Figure 3).
2
1. Connecting tabs
6. Mount the spark arrestor to the muffler guard with
(4) #10-24 x 1-1/4 inch hex-head screws, spacer
tubes and locknuts (Figure 4). Assemble the spark
arrestor with the exhaust pipe directed downward at
a 45 degree angle and away from engine.
Form No. 3362-910 Rev A
Installation Instructions
2
G011629
Figure 2
2. Cut off here
1
G011630
Figure 3
2. Knockout plug
Original Instructions (EN)
Printed in the USA.
All Rights Reserved