Sealey IWMH2003 Instructions page 2

Infrared quartz heater

page of 2

/ 2
Bookmarks

INTRODUCTION & SPECIFICATION

A totally dry heat, no condensation, no gas, no fumes and no smell. Reaches maximum heat output within seconds of being turned on. Highly polished

aluminium reflector for maximum heat efficiency. Adjusts horizontally through 25° while mounted. Three settings, controlled by pull chain, allow the unit to

be on low, half or full power. Ideal for industrial or domestic applications. Suitable for indoor use or outdoor use, if weather protected.

Power:

Input supply:

Dimensions (W x H x D)

MOUNTING INSTALLATION

3.1

WALL MOUNTING (fig.1).

(IMPORTANT! The following points should be noted): The heater

should always have a minimum clearance of 450mm from a ceiling

and at least 90cm from any object. Ensure that mounting surface is

capable of supporting the weight of the heater.

3.2

Remove the metal bracket from the heater by removing the

single screw from the underside of the bracket and sliding the

bracket down.

3.3

Use the bracket as a template, fix the metal bracket to the wall

by means of the four holes and appropriate fixings (not supplied).

3.4

Slide the heater back onto the bracket and secure using the

single screw.

3.5

Adjust the angle of heater to direct heat where required.

OPERATION

Note: The infrared lamp is fragile and therefore it is important that it is not subjected to any unnecessary shocks or vibration and is not moved

when it is on or until cooled down.

WARNING! Ensure you read, understand and apply the safety instructions in Section 1 before using the heater.

4.1

Ensure the heater is at least 90cm from any object. The heater can be tilted from -0° to 25°- set it to the required angle before switching

the heater on.

4.2

Plug in the heater and switch it on.

4.3

The heater has the following settings:

Position 0:

Off position.

Position L:

Middle element only.

Position M:

Two outer elements

Position H:

All three elements

4.4

Make sure the heater plug is disconnected from the mains supply before any cleaning is attempted. Also allow the heater to cool

completely. Do not use water or other liquids, or harsh abrasive cleaners to clean the heater.

4.5

Clean the exterior with a soft damp cloth with some mild detergent

4.6

When the heater is no longer required, switch off and unplug the unit.

4.7

To replace any of the lamps, contact your authorised Sealey dealer.

Declaration of Conformity

INFRARED QUARTZ HEATER

Model: IWMH2003

73/23/EEC Low Voltage Directive

89/336/EEC EMC Directive

93/68/EEC Marking Directive

2002/95/EC RoHS Directive

2002/96/EC WEEE Directive

NOTE:

It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.

IMPORTANT: No liability is accepted for incorrect use of this product.

WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.

INFORMATION: For a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.

2000W

230V 50Hz 13A

485 x 250 x 170mm

We, the sole importer into the UK, declare that the product listed here is in conformity with the following standards and directives.

The construction file for this product is held by the Manufacturer and may be inspected, by a national authority, upon request

to Jack Sealey Ltd.

Signed by Mark Sweetman

Sole UK Distributor

Sealey Group,