Advertisement
3.
OPERATION
WARNING! Ensure that you read, understand and apply the safety and operational instructions before applying
#
the tester probes to the battery. Only when you are sure that you understand the procedures is it safe to proceed
with the testing process.
3.1
PREPARATION
WARNING! Ensure that the vehicle, or battery, is in a well ventilated area before starting.
#
3.1.1
Check battery casing for cracks or leakage and confirm that it is 12 volts.
3.1.2
Clean battery terminals.
3.1.3
If possible, check electrolyte levels and top-up with distilled water as necessary.
DO NOT test for more than 10 seconds as damage may occur.
3.2
BATTERY TESTING
3.2.1
Press probe (fig.1.A) to the positive (+) battery terminal and probe (fig.1.B) to negative (-) terminal.
3.2.2
LEDs 1 through 3 at the bottom of the tester should light up showing a healthy battery, if less than 3 illuminate the
battery requires immediate maintenance.
NOTE: Some late models or larger vehicles may cause 4 LEDs to light up. This is OK.
3.3
ALTERNATOR TESTING
NOTE:
Idle the engine at 2000 rpm during the test (some vehicles may require a higher engine speed for an
accurate test).
3.3.1
Press the positive (+) probe (fig.1.A) onto the positive battery terminal and negative (-) probe (fig.1B) onto the
negative terminal.
3.3.2
The LEDs 1 through 3 should illuminate to show a healthy battery plus two more to show the alternator is working
efficiently. If only 1 illuminates or all LEDs illuminate the alternator is not working efficiently and will require
maintenance.
Declaration of Conformity
the UK, declare that the products listed here are in
conformity with the following standards and directives.
BATTERY AND ALTERNATOR TESTER
MODEL: TA301
2004/108/EC EMC Directive
2002/95/EC RoHS Directive
2002/96/EC WEEE Directive
93/68/EEC CE Marking Directive
2006/95/EC Low Voltage Directive
The construction files for these products are
held by the Manufacturer and may be
inspected, by a national authority, upon
request to Jack Sealey Ltd.
Signed by
Mark Sweetman
For Jack Sealey Ltd. Sole importer into the UK of
Sealey Professional Tools.
NOTE: It is our policy to continually improve products
and as such we reserve the right to alter data,
specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of
product.
WARRANTY: Guarantee is 12 months from purchase
date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue
and promotions call us on 01284 757525 and leave
your full name and address, including postcode.
We, the sole importer into
30th August 2007
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
01284 757500
01284 703534
email
fig.1
www.sealey.co.uk
Web
sales@sealey.co.uk
TA301 - 1 - 300807
Advertisement
