3D Fun Printz Universal Pen Holder Quick Start Manual
  1. Manuals
  2. Brands
  3. 3D Fun Printz Manuals
  4. Accessories
  5. Universal Pen Holder
  6. Quick start manual

3D Fun Printz Universal Pen Holder Quick Start Manual

Hide thumbs
1
2
3

Advertisement

Table of Contents

Universal Pen Holder Instructions

Thank you for purchasing the 3D Fun Printz Pen Holder
There are some tips below to get the best out of it.
Most importantly. The Pen Holder is partly made from PLA as it is a natural plastic
originating from corn starch and is recyclable. For these reasons it does not like heat.
Please don't leave it in the sun, on a hot windowsill, on or near a radiator or anywhere else
with a lot of heat.
Please also keep away from children and animals. PLA can be sharp when broken.
NEVER TRY AND ADJUST THE SCREW CAP WHILE THE HOLDER
IS IN YOUR MACHINE. YOU WILL DAMAGE YOUR MACHINE.
ALWAYS FULLY REMOVE THE HOLDER BEFORE ADJUSTMENT
To fit a pen into the holder clip the alignment clip onto the holder as shown. It should
remain loosely in place without holding. There are tabs that fit into the holes on the pen
holder

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Universal Pen Holder and is the answer not in the manual?

Questions and answers

Summary of Contents for 3D Fun Printz Universal Pen Holder

  • Page 1 Universal Pen Holder Instructions Thank you for purchasing the 3D Fun Printz Pen Holder There are some tips below to get the best out of it. Most importantly. The Pen Holder is partly made from PLA as it is a natural plastic originating from corn starch and is recyclable.
  • Page 2 Unscrew the top cap most of the way but not all the way off the pen holder. Insert your pen so the nib just touches the alignment clip as below. While gently holding the pen in place screw the top cap down so the flexible inserts retract into the holder and grip the pen.
  • Page 3 Unscrew the cap all the off the pen holder and place to one side. Using a microfibre or soft cloth gently wipe the threads on the pen holder and then inside the cap. Be careful when wiping the pen holder threads as the very top threads may have slightly sharp edges. Once you have wiped the threads apply a very small amount of oil or grease to the threads of the pen holder only at the top of the holder.

Table of Contents