Summary of Contents for Mennekes TwInlet Type F
- Page 1 Test box models TwInlet Type F, TwInlet Type E, TwInlet Universal for charging stations Giam, sequi bla On ships and Operating manual quam quat. Tat. terminals Version: 10/2017 - 03 Ibh ero dolendre...
- Page 2 About this document Explanation of safety symbols „ Translation of the original German-language manual. „ Must be read and kept in a safe place. „ Protected by copyright. DANGER! „ Duplication, reproduction or transmission, in whole or in Indication of a part, only with written consent.
-
Page 3: Table Of Contents
Service ..............5 Device overview ..........5 Scope of delivery ..........5 Features and variants ..........5 2.2.1 TwInlet Type F ..........6 2.2.2 TwInlet Type E ..........6 2.2.3 TwInlet Universal ........7 Technical data ............7 Nameplate ............7 Setting-up process .......... -
Page 4: For Your Safety
„ Plugs and sockets according to IEC 62196. electric shock, burns or death. f It is essential to comply with the safety information Test boxes are used to check MENNEKES charging stations. and instructions in this document. “Intended use” also includes compliance with the require-... -
Page 5: Operating Position
The device was in perfect working order at the time it left the factory. f In the event of complaints regarding the device, please contact MENNEKES or your responsible service partner immediately. Î Contact details on the rear of the device. -
Page 6: Twinlet Type F
2.2.1 TwInlet Type F 2.2.2 TwInlet Type E 2.2.1 / 1 2.2.2 / 1 Basic enclosure Basic enclosure Rocker switch for selecting vehicle inlet Rocker switch for selecting vehicle inlet Rocker switch for ventilation requirement Rocker switch for ventilation requirement... -
Page 7: Twinlet Universal
2.2.3 TwInlet Universal 2.3 Technical data 2.2.3 / 1 Nominal voltage 230 VAC (±10%) 400 VAC (±10%) Nominal frequency 50 Hz Nominal current 10 A Maximum back-up fuse rating 80 A Protection class IP 20 Dimensions (H x W x D) 260 x 225 x 165 mm Weight 3.3 kg 2.4 Nameplate... -
Page 8: Setting-Up Process
3. Setting-up process Requirements at the place of operation the test box. Use one charging inlet only at all times f Connect the charging cable to the MENNEKES charging DANGER! station. Risk of death due to improper use f Set the three rocker switches according to the vehicle Failure to comply with the specifications for the ambient status (one of A - E) that you wish to simulate. -
Page 9: Status C
For information on the ventilation requirements, please refer to the operating manual provided for the MENNEKES charging station. Setting for top rocker switch (I or II) For a single-phase charging cable, the L1 LED of the system 4.1.3 Status C... -
Page 10: Status E
5. Troubleshooting 4.1.5 Status E Fault Description „ Fault cause Simulation of communication fault between test box f Fault remedy and charging station Test box does not respond The charging station indicates a fault. If a charging process „ No supply of power to charging sys- is still active, this will be terminated immediately. -
Page 11: Storage And Disposal
Charging mode for vehicles f If, following the check, faults continue to occur, please with communication interface contact MENNEKES or your responsible service partner. at charging sockets of type 1 Î See rear of device for contact details. and type 2. - Page 12 Further information can also be found at our website www.MENNEKES-emobility.de MENNEKES service telephone number: +49 (0) 27 23 / 41-600 Service by Brochures can be requested by sending an e-mail to: MENNEKES ®...
Need help?
Do you have a question about the TwInlet Type F and is the answer not in the manual?
Questions and answers