Rear Deflector Adjustment; Skid Shoe Adjustment - Land Pride RTR1574 Operator's Manual

Section 3: Adjustments

Rear Deflector Adjustment

Refer to Figure 3-3:
Rear deflector (#1) can be adjusted closer to the ground
to produce a fine soil texture or can be raised to produce
a coarse soil texture. Adjust rear deflector by
repositioning chain (#2) in slot "A" .

Skid Shoe Adjustment

Refer to Figure 3-4:
The skid shoes can be adjusted to the desired tilling
depth by raising or lowering them as follows:
NOTE: Tilling depth is the vertical distance from
bottom of skid shoes to bottom of lowest tine. Be
certain both skid shoes are adjusted the same.
1. Raise tiller off the ground. Place a support under the
tiller (not under the skid shoes) and lower the tiller
onto the support. Make certain the tiller is secure
resting on the support before working on or around
the tiller.
2. Always place tractor in park, set tractor brakes, shut
tractor engine off, and remove switch key before
dismounting the tractor.
3. Loosen pivot bolt (#4) at the shoe's front.
4. Remove adjusting bolt (#2) and lock washer (#3) at
the shoe's rear.
5. Adjust skid shoe (#1) to the desired height.
1/19/21
Table of Contents
Rear Deflector
Figure 3-3
6. Reinstall adjusting bolt (#2) and lock washer (#3).
7. Tighten 1/2"-13 GR5 bolts (#2 & #4) to the correct
torque.
35874
Skid Shoe Adjustment
Figure 3-4
RTR1574 S/N+ Rotary Tiller 311-431M
35872
23