Ace 300 Quick Start Manual

ACE 300 CONTROL PANEL
Target ID Legend
indicates metal types.
Digital
Target ID
Mode
Indicator
Battery
Level
Power ON / OFF:
Indicator
hold 1 second to turn
power on/off.
MODE SENSITIVITY
Button Button
selects detection mode (i.e. increases or
discrimination pattern). decreases sensitivity.
2
Garrett Metal Detectors
Target ID Cursor
indicates probable target identity.
Depth
Lower Scale
Indicator
indicates notch
discrimination
indicates depth
pattern.
of coin-sized
target.
PINPOINT
Sensitivity
Button
Setting
Press and hold to
precisely locate a target.
DISCRIM and Accept/Reject
Buttons
Use DISCRIM (+) or (-) to select a
cursor. Then use (/X) button to set
its discrimination on or off.
Frequency Adjust
While holding down (/X) button,
use DISCRIM (+) or (-) to increase
or decrease frequency setting.
QUICK START GUIDE
1. Power ON.
Press and release the ON / OFF Power button. The ACE 300
powers on in the last mode used, automatically adjusts for
ground minerals and is ready to search. The detector
operates with four (4) AA batteries which are already
installed by Garrett.
(Factory default mode is Coins.)
2. Select Mode.
Use the Mode button to select a different detection mode,
when desired.
3. Adjust settings.
Adjust Sensitivity or Discrimination settings, if desired.
4. Begin scanning.
Lower the searchcoil to approximately 1 inch above the
ground and scan the coil left and right at approximately
3 ft/second. The coil must be in motion for target
detection, but can remain stationary during Pinpoint.
3
ACE 300™