Centralite AZELA ZIGBEE HA Quick Start Manual

www.centralite.com
4256050-ZHA,ZHAC
Warnings and Cautions:

To be installed and/or used in accordance with appropriate electrical codes and regulations.

If you are unsure about any of these instructions, consult a qualified electrician.
INTRODUCTION
The CentraLite Azela ZIGBEE HA Lamp Module uses the
Zigbee Home Automation(HA) communication protocol to
link with other Zigbee HA devices. Each Lamp Module
acts as a router for messages sent through the Zigbee
network.
FEATURES

Status LED

Load control from button on Lamp Module

Ease of installation

Compatible with other Zigbee HA certified level
controllers

ZHAC devices sense and report realtime load
current consumption
INSTALLATION
STEP 1
Attach the plug from the lamp to be con-
trolled into the receptacle of the Lamp
Module.
AZELA ZIGBEE HA Lamp Module
4256050-ZHA,ZHAC
Rated: 120 VAC, 60Hz
Rated 300W Incandescent @ 120V AC
STEP 2
Attach Lamp Module to wall receptacle.
Verify that the receptacle is powered. If
the receptacle is powered by a wall
switch, the wall switch must be kept ON
at all times for the module to operate
properly.
STEP 3
To join the ZIGBEE HA Lamp Module to
a certified HA controller be sure that the
HA controller is open for joining. If the
Lamp Module has not been joined to a
network then press and hold the Lamp
Module button. The Lamp Module will
then attempt to join an open HA network.
Upon a successful joining of the Lamp
Module to a Zigbee HA network the
status LED will blink 2 times. When the
Lamp Module powers up after being
joined to a Zigbee HA network, it will
blink 2 times.

Unplug unit when servicing connected lamps.

Save this instruction sheet. It contains important technical data along with testing
and troubleshooting information which will be useful after installation is complete.
If the Lamp Module will not join a Zigbee
HA network then:



Once the Lamp Module is joined to the
Zigbee HA network, use the certified HA
controller to configure the Lamp Module.
If it becomes necessary to remove the
Lamp Module from a Zigbee HA network
then you must factory default the Lamp
Module. To factory default the Lamp
Module:






STEP 3 cont'd
Make sure the Lamp Module is
powered up
Ensure the Lamp Module is within
RF range of a routing device
Make sure the target Zigbee net-
work is open for joining
STEP 4
STEP 5
Remove the Lamp Module from the wall
receptacle
Press and hold the Lamp Module button
Reinstall the Lamp Module into the wall
receptacle while holding the button
After 2 seconds the status LED will turn
ON
Once the LED is ON let go of the button
The Lamp Module will now be reset to
factory defaults and ready to join to a
Zigbee HA network.