Belintra Medicart with Powered Back Pack and optional USB lock Quick Start Manual

Quick start guide
Medicart with Powered Back Pack and optional USB lock
Immediately before any use, connect the Powered Back Pack to the mains with
the supplied spiral cable and let the battery charge until the LED indication stops
flashing (100%).

Battery status indicator

❱❱ ❱❱
The low voltage system in the Medicart indicates the battery status
using an LED indicator on the the back of the cart, and the Battery
Monitor application on the desktop of the PC (only if the application
has been installed).
The remaining charge in the battery is between 100% and 70%.
The LED flashes when the Medicart is not plugged in to the power socket. Leave the battery to charge as often as possible until
the LED indicator stops flashing. The battery is then 100% charged.
The remaining charge in the battery is between 69% and 40%.
The remaining charge in the battery is between 39% and 10%.
Repeated use of the Medicart with a battery charge of 30% or less reduces the life of the battery considerably.
The remaining charge in the battery is less than 10% when the LED is flashing red.
Plug the Medicart immediately into the power socket and leave the battery to charge to 100%!
When the battery charge has fallen to 5%, this pop-up will appear. A few minutes later, the PC will shut down and the
LED indicator will go out. The Medicart has gone into sleep mode.
Plug the Medicart immediately into the power socket and leave the battery to charge to 100%!
The built-in PC can be started with the on-off switch ICT at the rear of the Medicart.
• Briefly press the push button, the white LED lights up and the device is switched on.
• To switch the device off: briefly press the push button again.
• The white LED will now flash and the PC will shut down.
• The device switches off after 30 seconds.
• To force the device and PC to turn off: press and hold the button for 3 seconds.
The battery LED indicator remains active even when the main switch is
turned off. The LED indicator will only go out if the Medicart is in sleep mode
due to low battery.
The USB-controlled lock opens and shuts the Medicart. The way this is done
is determined by your system administrator.
© BELINTRA, NV – MDIT/QS/EN/0003 - 08/2019