Table of Contents
Advertisement
CHAPTER 5 CONTROL INTERFACE
Introduction
The SE4750 bi-directional control interface uses the industry-standard I
host-initiated command/response type protocol, and does not support unsolicited responses.
Command List
The SE4750 protocol supports the commands listed in
Descriptions on page
SE4750 Command List
Table 5-1
2
I
C Command Set
ACQUISITION
ACQUISITION_MODE
AIM
AIM_DURING_EXPOSURE
AUTO_POWER_REDUCTION
ENTER_BOOTLOADER
EXECUTE_SCRIPT
EXTERNAL_ILLUMINATION
GET_EXTENDED_STATUS
GET_PARAM
ILLUMINATION_DURING_EXPOSURE
ILLUMINATION_POWER_LEVEL
IMAGE_CAPTURE_MODE
5-5.
Opcode
0x58
0x5B
0x55
0x56
0x74
0x91
0x77
0x5A
0x79
0x70
0x59
0xF0
0x73
2
C protocol. The SE4750 protocol is a
Table
5-1. For detail on each command, see
Description
Starts and stops image data output.
Optimizes the SE4750 for a specific operation.
Turns the aim pattern on and off.
Captures the aim pattern in the image.
Places the SE4750 in a low power state when idle.
Enters bootloader mode.
Executes a programmed script.
Controls the operation of the EXT_ILLUM_EN signal.
Gets the SE4750 operating states.
Gets SE4750 parameters.
Turns illumination on and off.
Sets the illumination brightness level.
Sets the image capture mode.
Command
Advertisement
Table of Contents
