Subscribe to Our Youtube Channel
Summary of Contents for ATI Technologies PULSE-8
- Page 1 PULSE-8: MASTER PULSATION CONTROL Version - February 2006 For Software Version V1.02 Part Number - 39-0020...
- Page 2 Pulse-8 Features: Pulse-8 Operation : Terminate in a sealed, fused, double pole switched outlet fitted with a 13Amp (Type 1362) fuse or trip. A 3-pin ring...
- Page 3 CONTROL: 1 Siting: The PULSE-8 unit should be sited to allow easy access and minimal cable Connector Block: Mains Input, Solenoid Valve Operating Voltage Select and (+) Common Output. runs to the solenoid valves. The common (+) supply should be taken from either of the 2 connector block terminals and looped to all of the solenoids.
- Page 4 Stall 5 Stall 6 Stall 7 Stall 8 The illustration right shows a 16/16 parlour with the PULSE-8 in 4/1 configuration. The parlour is divided into 4 quadrants each of four stalls with one Vacuum Line PULSE-8 channel driving each quadrant. There is only one solenoid valve to each stall, so all four teat cups on a cluster are pulsed together.
- Page 5 Battery UP RESET SPLIT ACCESS INVERT Mains DOWN Ratio 1 Ratio 2 Freq Pulse-8 Master Pulsation System Channel Indicators: Access for Solenoid Illuminate when Valve cables Mains cable channel is on Use 2.5csa. entry gland Mode Select Switch: Ratio Select Buttons:...
-
Page 6: Specifications
UP or DOWN button for an increase or decrease in the value. the right hand end of the casing and the Pulse-8 will continue to operate. When mains is Channels 2 and 4 are altered in the same way but by pressing the RATIO 2 button instead. The restored disconnect the battery and switch the Power Source to the ON position new setting is displayed in the RATIO window.
Need help?
Do you have a question about the PULSE-8 and is the answer not in the manual?
Questions and answers