GWF Telecontrol TC-E Installation Manual

Building
technology
Installation Guide
Telecontrol – remote Display TC-E
Picture 1
1. Packaging includes
TC-E with battery, label versions for energy and volume
■
Installation accessories (screws, peg, user seal)
■
Installation Manual
■
2. Generics
TC-E is a remote display for indexes of meters equipped with
repetition output (e.g. reed-switch or open collector). The pulse
weight of TC-E and connected meter must fit together (adjust-
ment see 4.3).
In order to avoid any malfunction due to EMC the TC-E should
not be installed beside fluorescent lamps, electric motors,
switch boxes or other sources of electromagnetic influences.
Don't install signal lines in parallel to power lines. Recommen-
ded minimum distance app. 0,5m.
3. CE sign
This product conforms to CE regulations (environmental class
A according to EN 1434).
4. Installation
Tools: screwdriver (type PZ1), approx. drill Ø6mm
4.1 Wall mounting (Picture 2)
The installation on the wall can be done by using a screw
and wall plug (Ø6mm, L=30mm) or as an alternative by sti-
cking
(e.g. using double-sided tape).
Remove front cover screws and front cover
■
Remove battery (in case of using screws and wall plug)
■
Install back cover on the wall
■
Picture 2
4.2 Connecting the wires (Picture 3)
Cable diameters: Cable Ø4 – 5,5mm: pull the cable through
the cable insert (rubber part). Cable Ø6,3mm: don't use the
cable insert.
Remove cable sleeve app. 55mm
■
Strip insulation of single wires app. 5mm
■
Insert wires into holes inside PCB (terminals)
■
Respect the polarity (e.g. in case of open collector)!
■
Fix the terminal screws
■
Place cable inside the TC-E
■
Replace the battery. Respect the polarity!
■
A display test starts. During the test 3 different pictures are
displayed (each picture displayed for 3s).
Indication
Battery Polarity
Indication
Signal Polarity
Picture 3
Push
Button