Summary of Contents for Ress DP5
- Page 1 RESS Visual Inspection Sweep Instruments Measuring Instruments The Producer Manual Leakage Tester DP5...
-
Page 3: Table Of Contents
Page 9 2.7 N1-measurement (optional) Page 10 3. Troubleshooting Page 11 4. Language setting Page 11 5. Notification of fault Page 11 6. Working with the device Page 12 7. Declaration of conformity Page 12 RESS Leakage Tester DP5 Page 3... -
Page 4: Specifications
The Leakage Tester DP5 is also suitable for carrying out the 4/8 Pa-test, to check the negative pressure limiting value, in a simple and detailed procedure (according to the DVGW worksheet G 625 / 2010). -
Page 5: Working With The Device
The device is switched on/off at the front panel. The main menu will appear. Selection via the touch display. Now the test pressure can be selected. Enter measurements of the pipe. It is possible to enter up to three different pipe sections . RESS Leakage Tester DP5 Page 5... -
Page 6: Device Connections
Flattened connector side up! Pull plug sleeve backwards to remove! Hold onto cable! The plate must be screwed tightly to Infrared interface protect the device USB interface during transportation! charging account lamp RESS Page 6 Leakage Tester DP5... -
Page 7: Simpe 4/8 Pa-Test
Changing the voltage during operation will lead to measurement errors. After switching on the DP5 device, the measurement can be selected in the main menu. Before the measurement, both capillary tubes and the front plate must be connected. The negative pressure connection serves as a reference pressure and should be outside of the building. -
Page 8: Detailed 4/8 Pa-Test
The device simulates a chimney and is used as a controlled suction system. After switching on the DP5 device, the measurement can be selected in the main menu. Please wait until calibration is completed. Then both capillary tubes must be connected to the front plate. -
Page 9: Air Supply Test Recording
By pressing "save" a PDF file is created. A maximum of 10 measurements can be saved. The oldest file will be overwritten. The numbering is continuous. To transfer the files, the DP5 device must be connected to the computer via USB port. The USB port is behind the plastic cover the front plate. -
Page 10: N1-Measurement (Optional)
5cm behind the hose end. Then insert the sealing element into the stove connection piece or into the fireplace door. Switch on the DP5. The measurement is started via the menu item "40 pa". After entering the dimension, press "Next" to start the measurement. The device will self-test and then calibrate. -
Page 11: Troubleshooting
- Temperature too high, let the device cool down - Use power pack, battery voltage too low for measurement - Pressure sensor 125 Pa, switch device off and on again - Pressure sensor 5000 Pa, switch device off and on again RESS Leakage Tester DP5 Page 11... -
Page 12: Working With The Device
7. Declaration of Conformity Manufacturer: RESS GmbH & Co. KG Am Hasselbruch 28 D-32107 Bad Salzuflen declares that the product Product: Leakage Tester... - Page 13 RESS Visual Inspection Sweep Instruments Measuring Instruments The Producer RESS GmbH & Co. KG Am Hasselbruch 28 D-32107 Bad Salzuflen Tel. ++49 (0) 52 08 / 91 27 0 Fax ++49 (0) 52 08 / 80 30 info@ress.de Internet-store: www.ress.de...
Need help?
Do you have a question about the DP5 and is the answer not in the manual?
Questions and answers