Page 1
MODEL TM LINE FILTER INSTRUCTION MANUAL Make sure that the user has a copy of this manual at hand for use as an operating guide. T a i s e i K o g y o C o . , L t d . 6F, Imaimitsubishi Bldg.3-53-11 Minamiotsuka,Toshima-ku,Tokyo Japan Phone:+81-3-6912-9922 F a x:+81-3-6912-5921...
SAFETY PRECAUTIONS Thank you for purchasing an TM Oil Filter. This manual contains information and instructions on correct operation of your equipment. Before using the product, read this manual carefully and be sure you understand the equipment and safety precaution.
4 . P R O D U C T D E S C R I P T I O N 4-1. Dimensions and Component Parts Refer to attatched drawing 4-2. Construction and Principle of Operation The oil filter is composed basically of a body① , a loewr case② , an element③ , etc.
6 . S T O R A G E If the oil filter is not used immediately, store it with particular attention paid to the following. (1) Keep it in a clean and dry room. (2) If it is stored outdoors or in a humid place, cover it tightly with a vinyl sheet or equivalent.
(1) Make sure that service conditions are as specified in [3. Principal Specificat ions] in this manual. When the oil filter is used in a hydraulic system, its selection according to system pressure setting may turn out to be wrong in that the pressure actually imparted to the filter may be higher than the set level.
9-3. Cleaning Filter Element Clean the filter element with light oil (kerosine, gas oil, etc.) in the following manner. (1) Shake the filter element in four directions in the cleaning oil. (2) Brush the filter element carefully to remove sludge. (3) Blow off residual accumulations with an air spray.