Advertisement
CAUTION:
To reduce the risk of fire or electric shock:
• Do not mount or support cords or cables in a manner that can cut or damage wire insulation;
• Use only the adapter provided with this product;
• Make sure connectors are fully inserted and secured by fully fastening the connector rings.
Specifications
Input: AC 120V/60Hz, 2.6A (Max)
Output: AC 120V/60Hz, 4x0.65A (Max)
Model: PDR-031-120V
Before using or reusing, inspect the product carefully. Discard any products that have cut, damaged or frayed wire insulation or cords, loose connections,
or exposed copper wire.
IMPORTANT:
• Connect only standard LED lights without any functions.
• This product is equipped with an internal protection device (circuit breaker) that shuts off the power to an outlet when the outlet is overloaded. If
lights with amperage over 0.65 A are plugged to the outlet, the device will automatically switch off the outlet. Remove the lights and the outlet
will work normally again. See TROUBLESHOOTING.
1. Connect your LED lights (not included) to one of the four outlets of the product. The actual number of lights to be connected to each outlet varies
with the actual rated amperage of your lights. Please refer to the specifications and user manual of your lights. Do not exceed the maximum rated
amperage or it may cause damage to the product and/or user.
IMPORTANT: Connect only standard LED lights without any functions.
Plug
2. Plug the product to a wall or electrical outlet.
3. When not in use, unplug the product from power and store it in a cool, dry place away from sunlight.
4. When storing the product, carefully remove the product from wherever it is placed, including trees, branches, or bushes, to avoid any undue strain
or stress on the product conductors, connections and wires.
Lights of one (or more) of the outlets go off
• The outlet is overloaded. Unplug the power and wait for 30 minutes. Meanwhile check that the power output of your lights does not exceed 0.65 A,
the maximum capacity of each outlet. Replace with lights of less lighting load.
• Connect with only static, constant standard LED lights without any functions.
Lights flash abnormally
• Remove your lights and replace with only static/constant LED lights without any functions or controllers; the product should then work normally.
2
USE & CARE
TROUBLESHOOTING
OWNER'S MANUAL
Standard LED lights
(not included)
Advertisement
