Appendix 3: Analog Output Guide - BASF EXACTUS User Manual

Appendix 3
Analog Output
Hardware Setup:
There are four wires that must be connected between the Analog Output Module and the Digital
Interface Module. The two modules are designed to stack one above the other. BASF provides a
pre-made connector designed for use when the two modules are stacked. When the two modules
are stacked vertically the power input and digital communications connections are, pin for pin,
directly above one another. These connections are labeled D+, D-, Vs, and GND on both
modules. To connect the two modules, wire D+ on the Analog Output Module directly to D+ on
the Digital Interface Module, and do the same for D-, Vs, and the GND connections.
Figure A-15
-58-