Advertisement
Troubleshooting - Electrical connection
Problem
The milk does not froth when making a
cappuccino
The filter or espresso coffee has an acidic
flavour
The time taken to percolate the filter cof-
fee is getting longer
Electrical connection (UK only)
Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt
about your supply contact your local electricity company.
The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets
in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of and not left where children might find it and
plug it into a supply socket - with the obvious consequent danger.
N.B. We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use.
ImPOrTANT: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:
-
The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth
symbol
or coloured green or green and yellow.
-
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
-
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten
clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician.
Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced
with a flexible cord of the same size.
After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is
obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always
state this colour when ordering a replacement fuse cover.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should be fitted.
This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.
Possible causes
The milk is not cold enough
The milk-frother is dirty
Insufficient rinsing after the de-scaling operation
The coffee-maker filter needs de-scaling
green and yellow
blue
brown
Warning - this appliance must be earthed
Solution
Always use milk at fridge temperature
Clean the small holes in the milk-frother very
carefully, particularly those indicated in fig. 27
Rinse the appliance as described in the chapter
"De-scaling of the filter section" or " De-scaling of the
espresso section"
Carry out the de-scaling procedure as described in
the paragraph " De-scaling of the filter coffee section"
Green and Yellow to Earth
earth
neutral
live
Blue to
neutral
21
EN
13 amp
Fuse
Brown to
live
Cord Clamp
the mains lead
Advertisement
