Zennio ZVP-ACSR Technical Documentation

Security Relay
ZVP-ACSR
FEATURES
 Allows enhancing the security between the
electric door lock and the GetFace IP Basic
Unit, preventing system tampering. The relay
can only be activated if the valid opening code
is received from the GetFace IP Basic Unit. The
output can be:
 1 relay 30V/1A AC/DC (contacts NO/NC)
1 active output

 Dimensions: 56x31x24mm.
 Weight: 20g.
 Conformity with the CE directives.
SAFETY INSTRUCTIONS
 Installation should only be performed by qualified professionals according to the
laws and regulations applicable in each country.
 Do not connect the mains voltage nor any other external voltage to any point of the
signal wiring; it would represent a risk for the entire system. The facility must have
enough insulation between the mains (or auxiliary) voltage and the signal wiring or
the wires of other accessories, in case of being installed.
 Keep the device away from water and do not cover it with clothes, paper or any
other material while in use.
 The WEEE logo means that this device contains electronic parts and it must be
properly disposed of by following the instructions at http://zennio.com/weee-
regulation.
© Zennio Avance y Tecnología S.L.
12VDC/700mA max.
GetFace IP Unit
Reset button
Exit push button
Figure 2. Connection diagram
Ed. 2 Further information
GetFace IP
Technical Documentation
Figure 1. Security
Relay
Door lock
www.zennio.com Page 1 / 2