Summary of Contents for G.S.M Activate VAN001
- Page 1 GSM PROTECT ANTI-THEFT ALARM WITH GPS TRACKING & MOBILE PHONE ALERTS Remote monitoring & Control using your mobile phone. www.gsm-activate.co.uk MODEL NUMBER VAN001...
-
Page 2: Product Information
Product Information The GSM Protect is an anti-theft alarm that incorporates GPS and GSM capabilities and can be installed in many different applications such as cars, vans, mobile homes, boats, planes or any vehicle that has a battery. The unit has wireless and wired capabilities which will enable it to be triggered in a variety of ways. - Page 3 INSTRUCTIONS Before Powering On please assemble as below Simcard Push and click the simcard into position as shown IMPORTANT - PLEASE READ PLEASE MAKE SURE YOU DISCONNECT THE POWER WHEN YOU FIT THE SIMCARD THEN PLACE THE SIM CARD WITH THE CLIPPED CORNER IN FIRST Antennas The GSM Protect comes with three antennas that will need to be installed before you power on the device.
-
Page 4: Activating The Alarm
Powering on and Programming 1. Connect the 12 volts dc into the power in plug (refer to page 8) 2. Switch on the unit by pressing the switch towards position 1 3. The LED will be illuminated solid while it searches for a signal, when the signal has been found the LED willchange from solid to flashing every 20 seconds. -
Page 5: Wireless Pir
How to Use the 3G GSM PROTECT - Wireless Usage The GSM Protect has been designed to work in a variety of ways. It comes with a wireless PIR as well as wireless door contact, but will also allow wired connections which can also trigger the alarm. - Page 6 How to Use the 3G GSM PROTECT - Standard Usage Siren Once an alarm trigger has taken place the siren will sound for 2 minutes followed by the alarm turning itself off. It is now waiting for a new alarm activation command. How to Use GPS Tracking The alarm has a built in GPS tracking system.
- Page 7 How to Use the 3G GSM PROTECT - Hard Wired Usage For advanced users there are auxiliary and alarm inputs that can be used to enhance the security of your alarm by adding extra external hardware. Relay Output - Positins 1 2 3 The GSM Protect has a relay output that can be used to switch on external electrical devices such as lighting and additional sirens etc.
-
Page 8: Quick Reference
Quick Reference If the GPS is not warmed up. The antenna will be picking up a signal and will reply with the error message - “Waiting for valid GPS signal. Please Try Later” If there was a mistake when typing a text command a response will be “invalid command” For more technical support please browse the FAQ’s on our website www.gsm- activate.co.uk Alternatively email our technical support team at technical@gsm-...