Rinse Aid; Pour In Rinse Aid; Select Dosage - Asko D3330 Use And Care Manual

Rinse aid

Pour in rinse aid

Rinse aid, helps quicker the drying process.
When the rinse aid runs out, the rinse aid
symbol lights up on the panel.* Certain
machines do not have this function. There is
a refill indicator in the middle of the
dispenser (see picture). If the refill indicator
is totally black, there is sufficient rinse aid.
However, if the indicator has a more trans-
parent appearance, you need to top up with
rinse aid.
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser.
This is where you top up and set the amount
of rinse aid to be dispensed in each wash.
2. Fill until the indicator is totally black and
change the dosage as follows if required.
Do not forget to close the cover.

Select dosage

The dispenser is usually set at 1=soft water.
However, depending on the water hardness
you may need to change the dosage.
Open the rinse aid cover. Here you will find
the dispenser's adjustment dial. Settings 1-6:
the harder the water, the higher the dosage.
When the water hardness exceeds 10-
o
12 dH you should use rinse aid with citric
acid (acid rinse aid) if the machine does not
have a water softening filter. If the machine
has a water softening filter, dispense as for
soft water.
Too much rinse aid can lead to the build-up
of foam. If your water is particularly soft, you
can dilute the rinse aid (1 part rinse aid, 1
part water).
Too much rinse aid can cause streaks on
the dishes, while too little can result in water
stains.
22
When the rinse aid has run out, the rinse
aid symbol on the panel lights up.*
Refill indicator
Cover for rinse aid
Open by turning and lifting the cover!
*NB!
After filling, there may be a short delay
before the signal light goes out.
Open
Closed