Subscribe to Our Youtube Channel
Summary of Contents for LoadSurfer WH-25ES
- Page 1 Instruction Manual Pallet Truck with Scale Note: Owner/Operatormust read and understand this instruction manualbeforeusingthe pallettruckwithscale.
-
Page 2: General Specifications
Thank you for using this hand pallet truck with scale. For your safety and correct operation of the scale, please read these instructions carefully before using it. NOTE: (1) All of the information reported herein is based on data available at the moment of printing. The factory reserves the right to modify its own products at any moment without notice and incurring any sanction. - Page 3 4.2 HOW TO EXPEL AIR FROM THE PUMP UNIT Air may enter the unit when the seals are replaced. Lift the control lever (H01) to the LOWER position, then move the handle up and down for several times. 4.3 DAILY CHECK AND MAINTENANCE Daily check of the pallet truck can limit wear and tear of the unit.
-
Page 4: Weighing Operation
-Seals worn out or damaged. -Replace seals with new ones. Leaks -Check and replace with new -Some parts may be cracked or ones. worn out. -Impurities in the oil cause the -Replace with filtered oil. discharge valve (B) to fail to forks descend close. - Page 6 PARTS DRAWING OF PUMP ASSEMBLY...
- Page 7 PARTS LIST OF PUMP ASSEMBLY...
- Page 8 PARTS DRAWING OF HANDLE PARTS LIST OF HANDLE...
- Page 9 PARTS DRAWING OF FRAME Meter printer configuration A35L...
- Page 10 PARTS LIST OF FRAME...
- Page 11 9. WIRING DIAGRAM OF SCALE, JUNCTION BOX, SENSOR Instrument on the back, opened the box lid, wiring diagram...
-
Page 12: Changingthe Paper
J1～J4 Connect sensor connector white －S green ＋S black －E ＋E 10.CHANGINGTHE PAPER 10.1 Pull the lever to open the cover of the printer. Place the paper roll. Make sure the flap is at the top of the printer, facing towards you. Hold on to the paper when closing the printer. Push the cover closed firmly. 11.
Need help?
Do you have a question about the WH-25ES and is the answer not in the manual?
Questions and answers